Wash hands, skin and damp cloths in soap and warm water, then rinse.Ĭlean up when glue has dried: Use a sharp putty knife, razor, or sharp scraper to shave hardened glue from surface, then sand as needed. When areas have completely dried, sand as needed. Make as many passes as needed with the clean area of the cloth to remove all the glue. Note that clamping time can be dependent on temperature, humidity, and the porosity of the wood.Ĭure Time (amount of time for glue to reach total bonding strength): 24 hoursĬlean up while glue is wet: Use a clean, damp cloth to wipe off excess glue. In general, apply enough pressure that will cause a fine bead of glue to squeeze out when the proper pressure is applied.Ĭlamping Time (amount of time pressure needs to remain applied): 20–30 minutes for room temperature applications. The technique and type of clamp to be used is determined by many factors: the specific type of joint, type of stock or lumber, moisture content of stock, room temperature, assembly time and surface quality. 1 fluid ounce will cover approximately 1.6 square feet. Coverage: 1 gallon of Gorilla Wood Glue will cover about 200 square feet. Enough glue should be applied so that a fine bead of glue squeeze-out will occur when clamping. Rub together with the other surface to distribute the glue evenly on both surfaces. On hard-to-glue woods, apply the glue on both surfaces. In general, apply a generous amount of glue on one of the surfaces. Just how much Gorilla Wood Glue to apply depends on many factors. Also, be careful to avoid burnishing and end snipes.
#Gorilla wood glue free#
For laminating, the surfaces should be planed smooth, leaving the board surface free from machine marks, tear-out and snipes. NOTE: We do not recommend using any kind of alcohol, acetone, or other solvent.For best results, it is essential that the wood surfaces are prepared prior to application of glue. It is important to keep hands moist using moisturizers until the glue is fully removed. If you do get Gorilla Glue on your fingers or nails please follow these steps:ġ) Try removing the glue with a dry cloth or paper towel first (particularly if the glue is still tacky).Ģ) If that doesn’t work, try washing with a gritty soap and warm water, or using an exfoliator with a gritty texture.ģ) Dry your hands and apply lotion to moisturize your skin.Ĥ) Cured glue on fingers may stain skin temporarily and it may take several days to wear off. We strongly recommend wearing gloves while working on any project using Original, Clear or White Gorilla Glue. How do I remove Clear Gorilla Glue from my skin? How do I maximize the shelf life of Clear Gorilla Glue?Īfter use, wipe the nozzle with a dry cloth, close cap tightly and store at room temperature with access to light, if possible. Original or White Gorilla Glue are 100% waterproof and can withstand soaking and longer term water exposure, assuming the materials being are not significantly affected by the water. It is also minimally gap filling, which allows you to glue uneven surfaces.Ĭlear Gorilla Glue is water resistant, and can withstand intermittent exposures, however is not meant for a constant soak. Clear Gorilla Glue offers an extended working time, which allows you to reposition your project. It’s perfect for a fix you need done fast. Gorilla Super Glue is designed to dry fast and works best with tight fitting joints. What is the difference between Clear Gorilla Glue and Gorilla Super Glue? We realize any DIY project may have a spill and we want to help you with tips and tricks to successfully remove glue from fingers and nails.įor bonded skin, please call 1-80 to speak to a medical professional.
0 kommentar(er)
